Kyrex Setup Builder — Titan Two & Chiaki Remote Play

YOUR HARDWARE. YOUR PATH.

Build your
Kyrex setup.

Choose a path, add your hardware, then review your checklist.
You can plan without an account.

STEP 1 OF 4

Choose the route you want to explore. You can change it later.

Not sure? Chiaki is for PlayStation streaming. Titan Two covers controller and capture paths. Choose one to see what it requires.

Ready for the next step

Detailed Titan Two & Chiaki setup instructions

Titan Two setup

Install Gtuner IV and update Titan Two. Connect PROG to the setup computer.
For wired PC use, connect the controller to INPUT-A and OUTPUT to the gaming PC. Set the appropriate output protocol in Gtuner IV.
For console video, connect console HDMI to capture HDMI IN, then connect the card to your computer. HDMI OUT can feed a display when the card supports passthrough.
Check your exact console and controller authentication requirements. Native PS5 games and Titan + Chiaki combinations need compatibility confirmation.

A microSD card is used for expanded storage and certain wireless setups; it is not a blanket requirement for basic wired PC use.

Chiaki Remote Play setup

Install chiaki-ng for your computer. On PS5, enable Settings → System → Remote Play. On PS4, use Remote Play Connection Settings.
Keep the console and computer on the same home network for initial setup. Prefer Ethernet for the console.
Register the console in chiaki-ng using its PSN or PIN registration flow. Enter any PSN credentials or console PIN only in that trusted flow, never on Kyrex.
Test the video stream and controller input locally. Start with a supported 30 or 60 fps profile; reduce quality if unstable.
To wake from rest, enable internet connection and network wake in the console’s rest-mode settings.

Remote Play receives video over the network, so it does not need a capture card. Confirm your intended Kyrex input source with support.